Talaria XXX Key Ignition Swap: RFID Delete Conversion Guide

Every Talaria XXX leaves the factory with an RFID card instead of a key. It works, but it's one more thing to carry and one more thing to lose on the trail. Swapping to a key ignition, often called an "RFID delete", is one of the first changes many XXX owners make. Here's how the conversion works with our plug-and-play key ignition, from fitment to the last bolt.

Why riders convert from RFID to a key

• One key instead of a card. Turn it and ride, with nothing extra to keep track of.
• No wiring changes. Our ignition plugs into the grey connector the RFID unit uses, so there's no cutting, splicing or sanding.
• A cleaner cockpit. It sits where the RFID unit was, under the stock ignition cover.
• Reversible. Keep the stock RFID unit and you can switch back later.

Will it fit my bike?

• Talaria XXX (X3): yes
• Talaria XXX Pro: yes

It's made for the XXX and XXX Pro only, and for use with the stock plastic ignition cover. If you run an aftermarket ignition cover, email support@forged-racing.com before you install.

What's in the box

• Key ignition switch with dual-connector harness
• 2 black keys
• Install spacer
• Blue titanium-look protective cover (peel it off if you'd rather run it bare)

How to do the swap

Watch the full installation video on the product page before you start.

1. Power the bike off.
2. Remove the ignition cover and unplug the RFID unit. Keep it somewhere safe in case you want to switch back.
3. Fit the key ignition in its place.
4. Remove the left side panel and route the wire behind it.
5. Plug into the grey connector, the same one the RFID unit used.
6. Reinstall the side panel and the ignition cover.

Two things to watch

• The wire: route it with some slack, and keep it away from pinch points and sharp bends.
• Water: the ignition isn't waterproof. Keep it out of water.

FAQ

Do I need to cut or splice wires? No. It plugs into the stock connector.

Do I have to sand or trim anything? No. The dual-connector design fits without sanding or trimming, which some other ignitions need.

Can I still use the RFID card afterward? No. The key replaces the RFID unit. Keep the stock unit if you ever want to switch back.

Is it waterproof? While water-resistant, it is not fully waterproof. We highly recommend keeping the ignition out of water.

Finish the cockpit

Put your new key on a Forged Racing keychain so it's easy to find in a pocket or gear bag. For a small detail right in your line of sight, our titanium key ignition bolts come in Burnt Blue or Pink/Purple. Email us with your bike first to confirm they fit your setup. Looking for what to do next? See our guide to the best Talaria XXX upgrades.

Installation is at your own risk. Ignitions are final sale. See our liability disclaimer.