Talaria XXX Plug and Play Key ignition

Swap the RFID card for a key. This key ignition replaces the RFID reader on the Talaria XXX (X3) and XXX Pro. It plugs into the same grey connector the RFID unit uses, so the stock wiring stays untouched.

Fits: Talaria XXX (X3) and Talaria XXX Pro, with the stock plastic ignition cover. Using an aftermarket cover? Email support@forged-racing.com first.

In the box

• Key ignition switch with dual-connector harness
• 2 black keys
• Install spacer
• Blue titanium-look cover you can peel off

Install in five steps

Watch the install video first.

1. Turn the bike off.
2. Take off the ignition cover and unplug the RFID unit.
3. Fit the key ignition where the RFID unit was.
4. Pull the left side panel and run the wire behind it, with some slack and away from pinch points and sharp bends.
5. Plug into the grey connector, then refit the panel and cover.

Good to know

• No cutting, splicing, sanding or trimming.
• Your RFID card won't work afterward. Keep the stock unit if you might switch back.
• Not waterproof: keep the ignition out of water.
• Installation is at your own risk.

FAQ

Does it fit the Talaria XXX Pro?
Yes. It fits the Talaria XXX (X3) and XXX Pro with the stock plastic ignition cover.

Do I need to cut or splice wires?
No. It plugs into the same grey connector the RFID unit uses.

Will my RFID card still work?
No. Keep the stock unit if you might switch back.

Orders usually ship the same or next business day from California. You'll get a tracking number by email as soon as your order leaves our shop. Delivery time depends on your location and the method chosen at checkout.

Products are covered against manufacturing defects. If something isn't right, reach out — our dedicated support team is here to help at Support@forged-racing.com and we'll make it right.

Read our Liability Disclaimer before purchase and installation.